Stoll CMS 520 C+ - Setting Value for Releasing Thread Clamp

170
4 Adjusting knitting machine
Basic settings
Setting v alue for releasing thread clamp
4.1.16 Setting value for releasing thread clamp
The thread clamping and cutting device holds the thread of a yarn carrier not
used for knitting at the moment. When the yarn carrier is used again, the
carriage opens the clamping device after knitting a few rows and the yarn end
is released. The clamp is released after 19 knitting rows as standard. This
value can be set individually for each yarn carrier in the "Release clamps"
window.
Release clamps window
"Release clamps" window
Keys for entering the valu e for releasing thread clamp
Keys for entering the value for releasing thread clamp
Setting value for releasing thread clamp:
1. Call up the "Release clamps" window from the "Main menu".
2. Tap the input field of the corresponding yarn carrier and enter a value. In
the defau
lt setting the value "20" which corresponds to 19 knitting rows
(value - 1) is set.
3. Confirm entries.
4. Call up "Main menu".
Key Function
Call up "Release clamps" window
Confirm entries
Call up "Main menu"