Stoll CMS 520 C+ - Carriage Speed

331
Setup Data 5
Setup2 Editor
Carriage speed
5.5.5 Carriage speed
Different carriage speeds can be entered for different knitting situations. The
indirect carriage speed only becomes effective when it is slower than the
normal speed.
Carriage speed Setup2
Further information:
 Table Tools [316]
 Helpers for Input [311]
 Setup2 Editor [309]
 Setup Data [303]
 Comparing Setup1 to Setup2 [305]
 File tools [317]
Explanation Value range (meters/
second)
MSEC Speed
(normal speed)
Minimum value: 0.05
Maximum value: 1.20
Step width: 0.05
MSEC0 Speed for empty rows (S0) Minimum value: 0.05
Maximum value: 1.40
Step width: 0.05
MSEC1 Speed for transfer rows Minimum value: 0.05
Maximum value: 1.20
Step width: 0.05
MSECI Speed with Intarsia Yarn Carrier
(CMS ADF-3:
Specification is not
taken into account)
Minimum value: 0.05
Maximum value: 1.00
(CMS-C: 0.7)
Step width: 0.05
MSECC Speed outside the needle bed when
the yarn carrier is brought in the
clamp or taken out of the clamp.
Minimum value: 0.05
Maximum value: 0.50
Step width: 0.05
MSECK Carriage speed for small knots over m
rows, standard: 1 row
Minimum value: 0.05
Maximum value: 1.20
Step width: 0.05
MSEC2-20 Speed for knitting rows Minimum value: 0.05
Maximum value: 1.20
Step width: 0.05
Comment Comment ASCII Characters