Stoll CMS 520 C+ - Advanced adjustments

188
4 Adjusting knitting machine
Advanced adjustments
Advanced adjustments
4.2 Advanced adjustments
This chapter contains information on:
 Switching on and off aggregates * [189]
 Setting language [192]
 Adjusting sensor mechanism * [194]
 Setting needle bed parameters [196]
 Setting machine parameters [197]
 Setting switch-off time when
a power failure occurs [
199]
 Copying service data [201]
 Carry out the reference run [203]
 Adjusting racking position correction VPK [206]
 Adjusting basic rackin
g correction VGK [
209]
 Correcting position of stitch cams
[212]
 Adjusting needle brushes [214]
 Coupling carriage assembly wide or n
arrow (CMS 822) [215]
 Adjusting needle detector [220]
 Adjusting yarn carriers [221]
 Adjusting yarn carrier limiters [223]
 Adjusting yarn carrier guide [224]
 Adjusting the brushes of the central lubrication * [224]
 Adjusting intarsia yarn ca
rrier
(type 1) * [225]
 Adjusting intarsia yarn carriers
(type 2) * [226]
 Shifting intarsia yarn carriers in area of carriag
e assembly * [227]
 Intarsia yarn carrier - Adjust stoppin
g point (basic setting, braking value)*
[228]
 Intarsia yarn carrier - check the pr
essure plates * [237]
 Intarsia yarn carrier - Correct stopping point (correction value) * [
239]
 Float slider (holding-down jack control) [240]
 Normal yarn carrier type 2 [243]
 Plating – the different possibilities [245]
 Plating - Double bow yarn carrier [247]
 Plating - Plating yarn car
rier car
riage [249]
 Changing the position of the knock-over wire [252]
 Overview of all machine data [254]