493
Software - Installation and basic settings 8
Installing the Stoll operating system
Indirect installation
8.4.2 Indirect installation
In the case of Indirect Installation the new Stoll operating system is
immediately transmitted on the hard disk of the knitting machine ("Software
update" window).
Overview:
S
tart the installation process by switching on the machine. A message
pro
mpt displays that a new Stoll operating system is available for
installation.
You have to make a decision here whether you wish to install the new Stol
l
operating system or wish to continue with the old one.
Determine with the "Installation without configuration" check box
whether
the new Stoll operating system should be installed with simultaneous
configuration of the machine parameter.
Configure the machine if you have deactivated the
"Installation without
configuration" check box or carry out a reference run if you have activated
the "Installation without configuration" check box.
Deactivate the "Installation without configuration" check box, if
the machine parameters are also to be altered simultaneously
with the installation of the new Stoll operating system.
Activate the "Installation without con
figur
ation" check box, if
you do not want to alter any machine parameters. This
shortens the installation process.
The current operating system version will be overwritten!
When you install a new Stoll operating system version the
current on
e is overwritten.
Carry out the following steps only if you want to r
eplace the
current operating system by the previous version.
Save the machine data and the files specifically the ones
you
have created before the installation process.
To Next Page
Loading...