Stoll CMS 520 C+ - Adjusting Needle Detector

220
4 Adjusting knitting machine
Advanced adjustments
 Helpful knitting rows [378]
 Switching power supply 40 V off and on [375]
 Removing and mounting carriage part [409]
 Removing cam plate [419]
Adjusting needle detector
4.2.14 Adjusting needle detector
The needle detector is correctly adjusted if:
Adjusting t he needle detector
Adjusting the needle detector
 it is near the holding-down jacks of the rear needle bed, however does not
tap them
 the lower end of the needle detector is at t
he level of the needle hooks
➜ Staggering yarn carriers.
Further information:
 Staggering yarn carriers [145]
NOTICE
Damage to the needle detector!
If several yarn carriers are
stopped at the same place, the
needle detector will be damaged, as the yarn carriers cannot
avoid the needle detector.
➜ Alw
ays stagger yarn carriers.