499
Software - Installation and basic settings 8
Installing the Stoll operating system
Updating software
8.4.3 Updating software
A new Stoll operating system can also be copied on the hard disk while the
machine is producing. No data is overwritten here; the operating system is
loaded into a separate memory area.
This saves a few minutes time, as cop
ying occur
s during production. The
updating is not carried out until later, i.e. when the machine is switched off and
on again at the main switch. A prompt appears, asking you whether the new
operating system shall be loaded.
If
the question is answered with YES, th
en the new Stoll operating system
is installed.
If it is answered with NO, then this question is
asked again the next time
you switch on whether the new Stoll operating system should be installed.
For the software update the source from where the new Stoll operating s
ystem
should be copied can be selected.
Keys for updating the software
Keys for updating the software
Key
Function
Call up the "Service" menu
Call up the "Software updating" window
Key "Select source folder"
Key "Carry out update"
Key "Update display"
Save changes and end setting process
End setting process without saving changes
Call up "Main menu"
To Next Page
Loading...