372
6 Maintenance of the knitting machine
Lubricate knitting machine
Greasing the control sliders (CMS 822)
6.3.13 Greasing the control sliders (CMS 822)
Greasing the control slider
Greasing the control slider
➜ Apply grease to the control slider with a brush.
Greasing racking device
6.3.14 Greasing racking device
To ensure that the greasing of the racking spindle will not be forgotten, the
"Grease racking spindle" message appears after 180 days.
Greasing racking device
Greasing racking device
1. Position the rear needle bed at an angle.
2. Remove the cover over the racking spindle.
3. Apply grease to the racking strip and to the sliding guidance with a brush.
4.
Grease the lubricating nipple (1) with a grease gun (Klueb
er Staburags
NBU 12/300 KP, ID 231 191)
Further information:
Remove needle bed or position it at an angle [399]
To Next Page
Loading...