333
Setup Data 5
Setup2 Editor
Yarn length
5.5.7 Yarn length
Basic se ttings
Basic settings
Further information:
Helpers for Input [311]
File tools [317]
Table Tools [316]
Setup Data [303]
Overview of the Setup2 Editor of the CMS [309]
Comparing Setup1 to Setup2 [305]
Explanation
"Operating
mode for
patterns"
Determine the yarn length control mode.
: On the CMS the mode can be changed here.
◆
Production without YLC
◆ Working with mm
◆ Working with original fabric
◆ According to Sintral specification
"Correction
data (Working
with mm)"
No correction data was determined yet.
Correction data was determined.
"Original fabric
data (Working
with original
fabric)"
"Wheel" left device: Select measuring wheel (n=9 to 16).
right device: Select measuring wheel (n=1 to 8).
"Y" Select the yarn carrier (1A to 8D) working with this
measuring wheel.
"Comment" Comment (ASCII Characters)
To Next Page
Loading...