247
Adjusting knitting machine 4
Advanced adjustments
Plating - Double bow yarn carrier
4.2.28 Plating - Double bow yarn carrier
Clamping and cutti ng bed 2 x16, plating
Clamping and cutting bed
2x16
When using 16 times clamping / cutting, every other clamping / cutting point
has to be deactivated to ensure that both threads are reliably clamped and cut.
Carry out the settings in the "Machine Configu
ration 2" window.
(BootOkc -> Restart and Configuration ->
Machine configuration 2)
Setting: 2x16/8
Adjust the double bow yarn carrier
Adjust the double bow yarn
carrier
Central bow (1) - adjust
height:
1. Loo
sen the screw (3) (turn by 90 degrees).
2. Adjust the central bow the same way as the n
ormal yarn carrier.
3. Retighten the screw.
Follower bow (2) - adjust
height:
1. Loo
sen both screws (4) (turn by 90 degrees).
2. Adjust the height turning the screw (5).
Default setting: 2 mm higher than the central bow.
3. Retighten both screws (4).
4. Turn the screw (5) enough to prevent it from touching the upper or lower
edg
e. If
the screw is making contact, then the yarn carrier does not move
smoothly and will be damaged.
1
Central bow (fixed)
Plating Yarn
2
Follower bow (movable, following the central
bow)
Basic Yarn
To Next Page
Loading...