94
3 Producing with the knitting machine
Production
Calling up report and shift counters
3.3.2 Calling up report and shift counters
The control collects all operating data recorded since the operating system
was first read in and since the current knitting program was started. These
data help you optimize the performance and loading of the knitting machine.
Report The individual types of operating data (1) ar
e listed on the left side. The left-
hand table (2) shows the continuing listing of all data accrued after loading the
operating system. The data of this table cannot be deleted. The data of the
right table (3) can be deleted with the "Report0" key.
The production data can be listed dur
ing a
certain period of time. This may
consist of part of a shift, day or week.
Report wi ndow
"Report" window
Data in Report window
Label
Data shown
"F"
No. of errors or no. of stop motions
"%", "H", "M"
Percent, hours, minutes
"SIN"
Working time of the control unit (SINTRAL)
"RUN"
Production period
"V=V"
Stop by stopping at the engaging rod
"/-\"
Stop by yarn control device, yarn feed
"000"
Stop by piece counter
">!"
Stop by stop resistance
"-/)"
Stop by position needle sensor
"%"
Stop by fabric take-down
"PR"
Stop by programming
"MS~"
Machine stop (further causes of the stoppage)
To Next Page
Loading...