484
8 Software - Installation and basic settings
Saving pattern after a big fault
5. Tap on the "Copy Dongle" key.
The entire machine data are saved under the mcnumber.dgl on
the
USB-Memory-Stick (mcnumber = machine number) file name.
6. Call up "Main menu".
7. Take out the USB-Memory-Stick.
Further information:
Copying service data [201]
Load the machine settings in the machine computer
[480]
Saving p attern after a big fault
8.3 Saving pattern after a big fault
No "Warm start" can be made after a big fault of the control (e.g. system
crash). You have to carry out a "Restart". You will be asked whether the
logfiles and the pattern which has been loaded recently are to be saved.
If you do not want to save the logfiles and the patter
n, then tap on the "NO"
key. The "Restart " is carried out. Load the new knitting program.
Loading of the machine settings with the "Load Dongle" key in
the "Basic Settings" window.
To Next Page
Loading...