480
8 Software - Installation and basic settings
Boot process
Load the machine s ettings in the mac hine computer
Load the machine settings in
the machine computer
The machine settings do not only contain the machine data, but also the
machine options, the machine configuration, the report, the network settings,
and other internal control information. This data is referred as Dongle. Dongle-
Data are saved in a file with the mcnumber.dgl (mcnumber = machine number)
name.
A
file with dongle data is available.
1. Tap
the "Load Dongle" key.
A selection window for opening a file
is displayed.
2. Select Dongle-file (mcnumber.dgl).
3. Confirm input.
4. When the network settings are availabl
e, the question appears whether
these should be read also. If you answer this question with "Yes" the
network settings are loaded and a Reboot is automatically run.
The
machine settings are copied to the machine. Aft
er the copying is
complete, a message appears.
Saving d ongle data
Saving dongle data The machine settings do not only contain the machine data, but also the
machine options, the machine configuration, the report, the network settings,
and other internal control information. This data is referred as Dongle. Dongle-
Data are saved in a file with the mcnumber.dgl (mcnumber = machine number)
name. It is important to back up the data, e.g. when the hard disk is replaced.
1. Tap on the key "Save Dongle".
A s
election window for saving a file is
displayed.
2. Select the saving location.
3. Confirm input.
The machine settings are copied on the tar
get medium (file name:
mcnumber.dgl).
The current machine settings will be overwritten!
When you copy the machine settings to th
e hard disk, the
current machine settings are overwritten.
Only carry out the following step
s if you want to replace the
current machine settings with the settings saved on the file.
To Next Page
Loading...