486
8 Software - Installation and basic settings
Installing the Stoll operating system
Installing the Stoll operating system
8.4 Installing the Stoll operating system
The Stoll operating system can be installed in two ways:
Direct Installation:
After s
witching on the main switch, the
"BootOkc" window gets displayed.
Type in within the waiting time for the warm start on the "Basic Settings"
key, and select the memory location of the new Stoll operating system in
the "Basic Settings Menu" window. Go back to the "BootOkc" window, and
type on the "Installation" key or "Installation and Configuration". The
installation process is triggered.
When you tap on the "Installation" key, the installation is run
through t
ill the
"Reference run" window.
When you tap on the "Installation and Configuration" key, the machi
ne can
be configured afresh for stopping the installation.
Indirect Installation:
Duri
ng the production the new Stoll operating system is copied on the
hard
disk. You use the "Updating software" window for this purpose.
When the machine is switched on again the software can determine that
a
new Stoll operating system is available for installation. You will be asked
in one window whether you want to install the new Stoll operating system
and whether you wish to configure the machine anew simultaneously. If
you acknowledge this process with "Yes" the installation process gets
started with or without configuration.
In the next sections the different types
of installations will be
discussed at
length.
Direct installation [487]
Indirect installation [493]
Updating software [499]
Carrying out a rest
art (Restart)
[503]
Carrying out restart with machine conf
iguration (Restart and
Configuration) [504]
Setting online connection [506]
Overview of all system data [508]
To Next Page
Loading...