Stoll CMS 520 C+ - Replacing parts

380
7 Repairing the knitting machine
Replacing parts
Replacing parts
7.3 Replacing parts
This chapter contains information on:
 Replacing needle and coupling part (CMS 530, CMS 502, CMS 822, CMS
803) [381]
 Replacing needle and coupling part (CMS 830 C) [382]
 Replacing needle and coupling part
(CMS 520 C+) [384]
 Replacing intermediate slider [387]
 Replacing selection jack [390]
 Replacing holding-down jack (CMS 530, C
MS 502, CMS
822, CMS 803)
[391]
 Replacing holding-down jack (CMS 830 C) [392]
 Replacing holding-down jack (CMS 520 C+) [
395]
 Remove needle bed or position it at an angle [399]
 Repairing needle bed and additional needle bed [402]
 Removing selection jack bed (
CMS
520 C+, CMS 830 C) [406]
 Removing and mounting carriage part [409]
 Removing cam plate [419]
 Removing and mounting step motor [420]
 Replacing gear racks in the step motor [422]
 Replacing yarn carrier [426]
 Mount intarsia yarn carrier * [427]
 Replacing yarn control unit [429]
 Friction feed wheel - Replacing driv
e b
elts and friction roller [431]
 Deaerating oil line [433]
 Replacing comb hook [435]