498
8 Software - Installation and basic settings
Installing the Stoll operating system
11. If other NPK values are to be used, change the values and confirm the
changes.
12. Proceed to the next window.
The "Knit Report Configuration" window is displayed.
13. If other s
ettings are to be used, change the settings an
d confirm the
changes. Use the "additional function keys" to activate/deactivate the
running time control and/or running time measurement.
14. Proceed to the nex
t window.
T
he configuration is complete.
The "Refer
ence runs" window is displayed.
15. Continue with the next section.
Start reference runs The "Reference runs" window is displayed.
1. If the
racking device is not in the hom
e position, cast-off the stitches of a
needle bed.
2. Carry out reference run(s).
3. Proceed to the next window.
The
installation process is complete and the "Main
menu" is displayed.
Further information:
Configure machine [474]
Configuring network [476]
Load the machine settings in the ma
chine computer
[480]
Saving dongle data [480]
Updating software [499]
To Next Page
Loading...