434
7 Repairing the knitting machine
Replacing parts
4. From the "Main menu" call up the "Service" window.
5. Call up the "Central lubrication" window.
6. Set "Ventilation" switch to "On".
The pump feeds oil into the oil line.
7. If o
il comes out of the hole of the vent screw, set "Ventilation" (6
) switch to
"Off".
8. Tighten vent screw again (9.5 Nm).
9. Repeat the ventilation process at a
ll lubrica
tion units.
10. Call up "Main menu".
To Next Page
Loading...