461
Repairing the knitting machine 7
Needle selection displacement
7. Carry out the test series.
8. Tap the "Reset" (1) key.
The active line (2) of the test series is highlighted.
9. Engage the machine.
Th
e carriage moves very slowly from right to left (MSEC=0.15).
10. W
hile the carriage is running you perfor
m a visual inspection. Check
whether all the needles are driven out for knitting or not.
11. Stop the carriage in the left reversing point.
12. Enter the test result in the table.
If all the needles are driven out, you do not need to enter anything,
as
"OK"
is entered by default in the active line.
- or -
➜ If one or more needles are not driven out, set the switch (4) to "0". An "F"
is
entered in the table.
13. Engage the machine and check the needle selection in the other car
riage
direction.
A
Test for the front needle bed
B
Test for the rear needle bed
1
Reset
Delete the test results for the
front needle bed.
4
Enter the test result (carriage
direction:
<<)
2
Current line of the test series
5
Proceed to the next line
3
Enter the test result (carriage
direction: >>)
Switch setting "1" – OK
Switch setting "0" – F (Error)
6
Calculating the optimal
reaction time
7
Reset
Delete the test results for the
rear nee
dle bed.
To Next Page
Loading...