530
10 CMS 822 - Operating modes and particularities
Unusual features in the tandem with comb operating mode
"Comb upward" command This command ("=^=") may only appear in an empty course (two knitting rows
without knitting specifications). Here, the left or right carriage is stopped in the
exact center of the needle bed so that the needle detector is not damaged by
the upward moving comb take-down.
Ro
w 1: S0 =^=
Row 2: S1
Staggering of ya
rn carriers
It can happen that the yarn carrier positions need to be corrected with two-
pie
ce knitting.
Staggering of yarn carriers
Staggering of yarn carriers
Reminder: The CMS 822 functions as a four-system machine in this operating
mode.
This means that correction of the yarn carrier positions with two specifications
must be performed.
The stop position of the yarn carrier is corrected with the "YD" specification
outside the
SEN area (e.g. YD2=8-8;). It is position "1" and "4" in the
example above.
The stopping position of the yarn carrier is specified with the yarn
carrier
correction within the SEN area. The figure above shows specifications "Y-
2A:K0-8;" and "Y-2B:K8-0;", for example.
The left value for yarn carrier "2A" and the right value for yarn c
arrier "2B" can
have the value "0", as this value is not taken into consideration and the "YD"
specification is in effect.
The following description is valid only when work is done with
"#L", "#R" ("#LM", "#RM").
If work is carried out with "#L1", "#R1", "#L2" and "#R2", the
stopping positions ("YD") will be executed on the left and the
right selvedges of the fabric of both parts.
To Next Page
Loading...