Stoll CMS 520 C+ - Page 9

9
6.2.7 Cleaning the permanent brakes................................................................................... 353
6.2.8 Cleaning the friction feed wheel * ................................................................................ 354
6.2.9 Cleaning main drive fan *............................................................................................. 354
6.2.10 Cleaning fan and radiators in right control unit ............................................................ 355
6.2.11 Cleaning filter mat of power supply unit....................................................................... 355
6.2.12 Thoroughly cleaning needle bed.................................................................................. 356
6.2.13 Clean the knitting systems........................................................................................... 358
6.3 Lubricate knitting machine ................................................................................................ 359
6.3.1 Lubrication interval....................................................................................................... 360
6.3.2 Setting lubricating interval for needle bed.................................................................... 362
6.3.3 Setting of central lubrication ........................................................................................ 363
6.3.4 Oil needle bed.............................................................................................................. 367
6.3.5 Restarting lubricating interval ...................................................................................... 368
6.3.6 Oiling jack bed ............................................................................................................. 368
6.3.7 Oiling yarn carrier rods ................................................................................................ 369
6.3.8 Oiling the control of the holding-down jacks ................................................................ 369
6.3.9 Oiling carriage guide rail.............................................................................................. 369
6.3.10 Greasing impulse sensor rails ..................................................................................... 370
6.3.11 Greasing butts of the coupling parts and intermediate sliders..................................... 371
6.3.12 Oiling lifting slide (yarn carrier plunger) ....................................................................... 371
6.3.13 Greasing the control sliders (CMS 822)....................................................................... 372
6.3.14 Greasing racking device .............................................................................................. 372
6.3.15 Grease needle bed support/adjustment pieces ........................................................... 374
7 Repairing the knitting machine ...................................................................... 375
7.1 Supplementary activities during maintenance................................................................... 375
7.1.1 Switching power supply 40 V off and on...................................................................... 375
7.1.2 Central lubrication - mounting and working position.................................................... 377
7.2 Helpful knitting rows.......................................................................................................... 378
7.3 Replacing parts ................................................................................................................. 380
7.3.1 Replacing needle and coupling part (CMS 530, CMS 502, CMS 822, CMS 803) ....... 381
7.3.2 Replacing needle and coupling part (CMS 830 C) ...................................................... 382
7.3.3 Replacing needle and coupling part (CMS 520 C+) .................................................... 384
7.3.4 Replacing intermediate slider ...................................................................................... 387
7.3.5 Replacing selection jack .............................................................................................. 390
7.3.6 Replacing holding-down jack (CMS 530, CMS 502, CMS 822, CMS 803).................. 391
7.3.7 Replacing holding-down jack (CMS 830 C) ................................................................. 392
7.3.8 Replacing holding-down jack (CMS 520 C+)............................................................... 395
7.3.9 Remove needle bed or position it at an angle ............................................................. 399
7.3.10 Repairing needle bed and additional needle bed ........................................................ 402
7.3.11 Removing selection jack bed (CMS 520 C+, CMS 830 C) .......................................... 406
7.3.12 Removing and mounting carriage part......................................................................... 409
7.3.13 Removing cam plate.................................................................................................... 419
7.3.14 Removing and mounting step motor............................................................................ 420
7.3.15 Replacing gear racks in the step motor ....................................................................... 422
7.3.16 Replacing yarn carrier.................................................................................................. 426
7.3.17 Mount intarsia yarn carrier *......................................................................................... 427
7.3.18 Replacing yarn control unit .......................................................................................... 429