Tektronix DPO70000 Series Programmer's Manual

Commands Listed in Alphabetical Order
offset value. T
he channel reference marker will move to the vertical g raticule
position given by the negative of the offset value divided by the scale factor,
unless that position is off-screen. If the computed coordinate for the reference
mark is off-screen, the mark moves to the nearest screen limit and changes from
a right-pointing arrow ( →) to an arrow pointing in the appropriate off-screen
direction.
Group
Vertical
Syntax
AUXIn:OFFSet <NR3>
AUXIn:OFFSet?
Arguments
<NR3> is the offset value for the specified channel.
Examples
AUXIN:OFFSet 2.0E-3 sets the offset for AUX In input to 2 m V.
AUXIN:OFFSet? might return :AUXIN:OFFSET 1.0000E-03, indicating that
the offset for AUX In input is set to 1 m V.
AUXIn:PRObe:AUTOZero (No Query Form)
The command sets the probe attached to the AUX In input to autozero.
Group
Vertical
Syntax
AUXIn:PRObe:AUTOZero EXECute
Arguments
EXECUTE sets the probe to autozero.
Examples
AUXIN:PROBE:AUTOZERO EXECUTE sets the probe to autozero.
AUXIn:PRObe:DEGAUSS (No Query Form)
This command starts a degauss cycle of the probe attached to the AUX In input.
The degauss cycle will change with an appropriate probe attached.
Group
Vertical
DPO7000, DPO70000/B and DSA7000/B Series Programmer Manual 2-89

Tektronix DPO70000 Series Specifications

General

Brand	Tektronix
Model	DPO70000 Series
Category	Test Equipment
Language	English