Tektronix DPO70000 Series Programmer's Manual

Commands Listed in Alphabetical Order
Examples
SEARCH:SEARCH
1:TRIGGER:A:SETHOLD:DATA:THR ESHOLD:MATH1 ECL
sets the Math 2 waveform setup/hold trigger data threshold setting for search 1
to -1.3 volts.
SEARCH:SEARCH1:TRIGGER:A: SETHOLD:DATA:THRESHOLD:MATH1? might
return
:SEARCH:SEARCH1:TRIGGER:A:SE THOLD:DATA:THRESHOLD:MATH1
1.0000
, indicating that the Math 1 waveform setup/hold trigger data threshold
setting for search 1 is set to 1.0 volt.
SEARCH:SEARCH<x>:TRIGger:A:SETHold:DATa:THReshold:REF<x>
This comm
and sets or queries the data threshold setting for a setup/hold trigger
search to determine where to place a mark. <x> is the search number or reference
waveform number.
Group
Search and Mark
Syntax
SEARCH:SEARCH<x>:TRIGger: A:SETHold:DATa:THReshold:REF<x>
{NR3|ECL|TTL}
SEARCH:SEARCH<x>:TRIGger: A:SETHold:DATa:THReshold:REF<x>?
Arguments
<NR3> is the clock level, in volts.
ECL specifies a preset ECL high level of -1.3 V.
TTL specifies a preset TT L high level of 1.4 V.
Examples
SEARCH:SEARCH1:TRIGGER:A: SETHOLD:DATA:THRESHOLD:REF2 ECL sets
the Reference 2 waveform setup/hold trigger data threshold setting for search
1
to -1.3 volts.
SEARCH:SEARCH1:TRIGGER:A: SETHOLD:DATA:THRESHOLD:REF1? might
return
:SEARCH:SEARCH1:TRIGGER:A: SETHOLD:DATA:THRESHOLD:REF1
1.4000
, indicating that the Reference 1 waveform setup/hold trigger data
threshold setting for search 1 is set to 1.4 volts.
SEARCH:SEARCH<x>:TRIGger:A:SETHold:HOLDTime
This command sets or queries the hold time setting for a s etup/hold trigger search
to determine where to place a mark. <x> is the search number.
Group
Search and Mark
2-466 DPO7000, DPO70000/B and DSA7000/B Series Programmer Manual

Tektronix DPO70000 Series Specifications

General

Brand	Tektronix
Model	DPO70000 Series
Category	Test Equipment
Language	English