Commands Listed in Alphabetical Order
Arguments
ON turns on mask
pass/fail testing.
OFF turns o ff mask pass/fail testing.
<NR1> = 0 turns off mask pass/fail testing; any other integer turns on mask
pass/fail testing.
Examples
MASK:TEST:STATE ON turns on mask pass/fail testing.
MASK:TEST:STATE? might return :MASK:TE ST:STATE 0, indicating that the
mask pass/fail testing is turned off.
MASK:TESt:STATUS? (Query Only)
This query-only command returns the pass/failteststatus. This command
returns one of: OFF, DELAY, PASSING, FAILING, PASSED, FAILED, and
VIOLATION. In other words, it indicates the result of the pass/fail test. When
the violation count exceeds the violation threshold, the status changes from
Passing to Failed.
Group
Mask
Syntax
MASK:TESt:STATUS?
Examples
MASK:TEST:STATUS? might return :MASK:T EST:STATUS PASSING indicates
pass test status.
MASK:TESt:STOP:FAILure
This command sets or returns the stop status on pass/fail test failure mode. When
enabled, this command causes the instrument to stop acquirin
g data when the
pass/fail status changes to ‘Failing’. Repeat-on-completion mode has no effect.
Group
Mas
k
Syntax
MASK:TESt:STOP:FAILure {OFF|ON|<NR1>}
MASK:TESt:STOP:FAILure?
Arguments
ON turns on the pass/fail stop on failure.
OFF turns off the pass/fail stop on fai
lure. This is the default.
DPO7000, DPO70000/B and DSA7000/B Series Programmer Manual 2-333
To Next Page
Loading...
Need help?
General
