Commands Listed in Alphabetical Order
SEARCH:SEARC
H<x>:TRIGger:A:RUNT:WIDth
This command sets or queries the width setting for a runt trigger search to
determine where to place a mark. <x> is the search number.
Group
Search and Mark
Syntax
SEARCH:SEARCH<x>:TRIGger:A :RUNT:WIDth <NR3>
SEARCH:SEARCH<x>:TRIGger:A :RUNT:WIDth?
Arguments
<NR3> specifi es the minimum width, in seconds.
Examples
SEARCH:SEARCH1:TRIGGER:A:R UNT:WIDTH 400E–12 sets the runt trigger
minimum width for search 1 to 0.4 nanoseconds.
SEARCH:SEARCH1:TRIGGER:A:R UNT:WIDTH? might return
:SEARCH:SEARCH1:TRIGGER:A: RUNT:WIDTH 500.00O0E-12, indicating that
the runt trigger minimum width for search 1 is set to 0.5 nanoseconds.
SEARCH:SEARCH<x>:TRIGger:A:SETHold:CLOCk:EDGE
This command sets or queries the clock slope setting for a setup/hold trigger
search to determine w here to place a mark. <x> is the search number.
Group
Search and Mark
Syntax
SEARCH:SEARCH<x>:TRIGger:A :SETHold:CLOCk:EDGE {FALL |RISe}
SEARCH:SEARCH<x>:TRIGger:A :SETHold:CLOCk:EDGE?
Arguments
FALL specifies the polarity as the clock falling edge.
RISe specifies the polarity as the clock rising edge.
Examples
SEARCH:SEARCH1:TRIGGER:A:S ETHOLD:CLOCK:EDGE FALL sets the
setup/hold trigger clock slope polarity for search 1 to falling edge.
SEARCH:SEARCH1:TRIGGER:A:S ETHOLD:CLOCK:EDGE? might return
:SEARCH:SEARCH1:TRIGGER:A: SETHOLD:CLOCK:EDGE RISE, indicating that
the setup/hold trigger clock slope polarity for search 1 is set to rising edge.
DPO7000, DPO70000/B and DSA7000/B Series Programmer Manual 2-461
To Next Page
Loading...
