Tektronix DPO70000 Series

Commands Listed in Alphabetical Order
SEARCH:SEARC
H<x>:TRIGger:A:SETHold:DATa:THReshold:CH<x>
This command sets or queries the d ata threshold setting for a setup/hold trigger
search to determine where to place a mark. <x> is the search number or channel
number.
Group
Search and Mark
Syntax
SEARCH:SEARCH<x>:TRIGger:A :SETHold:DATa:THReshold:CH<x>
{NR3|ECL|TTL}
SEARCH:SEARCH<x>:TRIGger:A :SETHold:DATa:THReshold:CH<x>?
Arguments
<NR3> is the clock level, in volts.
ECL specifiesapresetECL high level of -1.3 V.
TTL specifies a preset TTL high level of 1.4 V.
Examples
SEARCH:SEARCH1:TRIGGER:A:S ETHOLD:DATA:THRESHOLD:CH2 ECL sets
the Channel 2 setup/hold trigger data threshold setting for search 1 to -1.3 volts.
SEARCH:SEARCH1:TRIGGER:A:S ETHOLD:DATA:THRESHOLD:CH1? might
return
:SEARCH:SEARCH1:TRIGGER:A:SE THOLD:DATA:THRESHOLD:CH1
1.4000
, indicating that the Channel 1 setup/hold trigger data threshold setting for
search 1 is set to 1.4 V.
SEARCH:SEARCH<x>:TRIGger:A:SETHold:DATa:THReshold:MATH<x>
This command sets or queries the d ata threshold setting for a setup/hold trigger
search to determine where to place a mark. <x> is the search number or math
waveform number.
Group
Search and Mark
Syntax
SEARCH:SEARCH<x>:TRIGger:A :SETHold:DATa:THReshold:MATH<x>
{NR3|ECL|TTL}
SEARCH:SEARCH<x>:TRIGger:A :SETHold:DATa:THReshold:MATH<x>?
Arguments
<NR3> is the clock level, in volts.
ECL specifiesapresetECL high level of -1.3 V.
TTL specifies a preset TTL high level of 1.4 V.
DPO7000, DPO70000/B and DSA7000/B Series Programmer Manual 2-465