Commands Listed in Alphabetical Order
Arguments
<NR3> specifies
the cursor position.
Returns
A floating point value with an exponent.
Examples
CURSor:VBArs:POS2 9.00E-6 positions the cursor2 vertical bar cursor at 9 ms.
CURSor:VBArs:POS1? this command might return :CURSOR:V BARS:POS1
1.0000E-06
, indicating that the cursor1 vertical bar is positioned at 1 ms.
CURSor:VBArs:UNIts
This command sets or queries the units for the vertical bar cursors.
Group
Cursor
Syntax
CURSor:VBArs:UNIts {SECOnds|HERtz}
CU
RSor:VBArs:UNIts?
Arguments
SECOnds sets the units of the vertical bar cursors for the time domain (seconds).
HERtz sets the units of the vertical bar cursors for the frequency domain (Hertz).
Returns
A string for SECOn ds or HERtz, depending on the current vertical bar cursor units.
Examples
CURSOR:VBARS:UNITS HERTZ sets the units of the vertical bar cursors to
1/seconds.
CURSOR:VBARS:UNITS? might return :CURSOR:VBARS:UNI TS SECONDS,
indicating that the units for the vertic al bar cursor are cu rrently set to seconds.
CURSor:WAVEform
This command sets or queries the current settings for the waveform cursors o r
forces them to snap to positions speci fied by the DATA:START and DATA:STOP
commands.
Group
Cursor
Syntax
CURSor:WAVEform SNAp
CURSor:WAVEform?
2-140 DPO7000, DPO70000/B and DSA7000/B Series Programmer Manual
To Next Page
Loading...
Need help?
General
