Commands Listed in Alphabetical Order
TRIGger:A:SP
I:SS:SOUrce
DPO7000 Series o nly: This command sets or queries the SPI trigger Slave Select
(SS) source.
Group
Low Speed Serial Trigger
Syntax
TRIGger:A:SPI:SS:SOUrce CH<x>
TRIGger:A:SPI:SS:SOUrce?
Arguments
CH<x> specifies the source for the SPI SS signal. X can be 1, 2, 3, or 4.
Examples
TRIGGER:A:SPI:SS:SOURCE CH2 sets the SPI trigger Slave Select (SS) source
to channel CH2.
TRIGGER:A:SPI:SS:SOURCE? might return : TRIGGER:A:SPI:SS:SOURCE
CH1
, indicating that the SPI trigger Slave Select (SS) source is set to channel CH1.
TRIGger:A:TYPe
This command sets or queries the type of trigger. Logic and Pulse triggers
contain classes. Logic triggers consist of State and Pattern classe s; Pulse triggers
consist of Glitch, Runt, Width, Transition, Timeout, and Window classes. Once
you have set the trigger type, you may also need to iden tify the associated
trigger class. For details on selecting Logic and Pulse trigger classes, see
TRIGger:{A|B}:LOGIc:CLAss and TRIGger:{A|B}:PULse:CLAss respectively.
This command is similar to selecting Event Trigger Setup from the Trig menu and
then selecting the desired Trigger Type.
Some trigger types are not available on some instruments.
Group
Trigger
Syntax
TRIGger:A:TYPe {EDGE|LOGIc|PULse|VI Deo|
I2C|CAN|SPI|COMMunication |SERIAL|RS232}}
TRIGger:A:TYPe?
Related Commands
TRIGger:{A|B}:EDGE?, TRIGger:{A|B}:LOGIc:CLAss, TRIGger:{A|B}:
PULse:CLAss
2-598 DPO7000, DPO70000/B and DSA7000/B Series Programmer Manual
To Next Page
Loading...
Need help?
General
