Commands Listed in Alphabetical Order
Arguments
<QString> is th
e character string that will be used for the reference waveform
label name.
Examples
REF4:LABEL:NAME "My Reference" sets the label name of Reference 4
waveform to “My Reference”.
REF3:LABEL:NAME? might return :REF3:LABEL:NAME "Signal2", indicating
that the label name for Reference 3 waveform is currently set to “Signal2”.
REF<x>:LABel:XPOS
This command sets or queries the X screen offset at which the label (attached to
the displayed waveform of the specified reference) is displayed, relative to the
left edge of the screen The reference waveform is specified by x. The value of x
can range from 1 through 4. This command is equivalent to selecting Reference
Waveforms from the File menu, choos
ing Label from the drop-down list, selecting
the tab associated with the reference for which you want to position a label, and
entering a value in the X Position box.
Group
Vertical
Syntax
REF<x>:LABel:XPOS <NR1>
REF<x>:LABel:XPOS?
Related Commands
REF<x>:LABel?
Arguments
<NR1> is the location (control in divisions) where the waveform label for the
selected reference i s displayed, relative to the left edge of the screen. Arguments
should be integers ranging from 0 through 10.
Examples
REF4:LABEL:XPOS 10 moves the waveform label for the Reference 3 waveform,
so that it begins 10 divisions to the right of the left edge of the screen.
REF2:LABEL:XPOS? might return :REF2:LABEL:XPOS 1.5, indicating that the
x-axis for the Reference 2 waveform is currently 1.5 divisions to the right of the
left edge of the screen.
REF<x>:LABel:YPOS
This command sets or queries the Y screen offset at which the label (attached to
the displayed waveform of the specified reference) is displayed, relative to the
center of the screen. The reference waveform is specified by x. The value of x
DPO7000, DPO70000/B and DSA7000/B Series Programmer Manual 2-419
To Next Page
Loading...
Need help?
General
