Tektronix DPO70000 Series Programmer's Manual

Commands Listed in Alphabetical Order
MATH<x>:LABe
l:XPOS
This command sets or queries the X screen offset at which the label attached to a
math waveform is displayed, relative to the left edge of the screen. Channels are
specified by x
, which ranges from 1 through 4. This command is equivalent to
selecting Math Label from the Math menu and entering a value in the X Position
box.
Group
Math
Syntax
MATH<x>:LABel:XPOS <NR1>
MATH<x>:LABel:XPOS?
Related Commands
MATH<x>:LABel:YPOS
Arguments
<NR1> is the location (in divisions) where the label for the selected math
waveform is displayed, relative to the left edge of the screen. Arguments should
be integers ranging from 0 to 10.
Examples
MATH2:LABEL:XPOS 5 moves the waveform label for the Math 2 waveform
(on a four-channel instrument) so that it begins 5 divisions to the right of the
left edge of the scr
een.
MATH2:LABEL:XPOS? might return :MATH2:LABEL:XPOS 2.5, indicating that
the waveform labe
l for the Math 2 waveform is currently 2.5 divisions to the right
of the left edge o f the screen.
MATH<x>:LABel:YPOS
This command sets or queries the Y screen offset at which the label attached
to a math waveform is displayed, relative to the waveform handle. The Math
waveform is specified by x, which ranges from 1 through 4. This command is
equivalent to
selecting Math Label from the Math menu and entering a value
in the Y Position box.
Group
Math
Syntax
MATH<x>:LABel:YPOS <NR1>
MATH<x>:LABel:YPOS?
Related Commands
MATH<x>:LABel:XPOS
DPO7000, DPO70000/B and DSA7000/B Series Programmer Manual 2-349

Tektronix DPO70000 Series Specifications

General

Brand	Tektronix
Model	DPO70000 Series
Category	Test Equipment
Language	English