Commands Listed in Alphabetical Order
Arguments
50 sets the size
of the Zoom graticule to 50%.
80 set the size of the Zoom graticule to 80%.
100 sets the size of the Zoom graticule to 100%.
Examples
ZOOM:GRATICULE:SIZE 100 sets the zoom graticule size to 100%.
ZOOM:GRATICULE:SIZE? might return : ZOOM:GRATICULE:S IZE 100,
indicating that the zoom graticule size is set to 100%.
ZOOm:HORizontal:POSition
This command sets or queries the horizontal position around which the zoom
waveform is displayed. It is freely movable within the confines of the acquired
waveform (0% to 100%) and measured from left to right of the acquired waveform.
Group
Zoom
Syntax
ZOOm:HORizontal:POSition <NR3>
ZOOm:HORizontal:POSition?
Arguments
NR3 is a value from 0 to 100.00 and is the percent of the waveform that is to the
left of screen center, when the zoom factor is 1× or greater.
Examples
ZOOM:HORIZONTAL:POSITION 50 sets the horizontal position to 50.
ZOOM:HORIZONTAL:POSITION? might return :ZOOM:HORIZONTAL:POSITION
23.90000
, indicating that the horizontal position is set to 23.9.
ZOOm:HORizontal:SCAle
This command sets or queries the zoom horizontal scale factor around which the
zoom waveform is displayed.
Group
Zoom
Syntax
ZOOm:HORizontal:SCAle <NR3>
ZOOm:HORizontal:SCAle?
Arguments
<NR3> is the amount of expansion in the horizontal direction in 1-2-5 increments.
2-650 DPO7000, DPO70000/B and DSA7000/B Series Programmer Manual
To Next Page
Loading...
Need help?
General
