Tektronix DPO70000 Series

Commands Listed in Alphabetical Order
SEARCH:SEARCH
1:TRIGGER:A:WIDTH:LOWLIMIT?
might return
:SEARCH:SEARCH1:TRIGGER:A :WIDTH:LOWLIMIT 500.0000E-12,
indicating that the width trigger lower time limit setting for search 1 is set to 0.5 ns.
SEARCH:SEAR
CH<x>:TRIGger:A:WIDth:POLarity:CH<x>
This command sets or queries the polarity for a width trigger search to determine
where to place a mark. <x> is the search number or channel number.
Group
Search and Mark
Syntax
SEARCH:SEARCH<x>:TRIGger: A:WIDth:POLarity:CH<x>
{NEGAtive|POSITIVe}
SEARCH:SEARCH<x>:TRIGger: A:WIDth:POLarity:CH<x>?
Arguments
NEGAtive specifies a negative polarity.
POSITIVe specifies a positive polarity.
Examples
SEARCH:SEARCH1:TRIGGER:A: WIDTH:POLARITY:CH2 NEGATI VE sets the
Channel 2 width trigger polarity setting for search 1 to NEGATIVE.
SEARCH:SEARCH1:TRIGGER:A: WIDTH:POLARITY:CH1? might return
:SEARCH:SEARCH1:TRIGGER:A :WIDTH:POLARITY:CH1 POSIT IVE,
indicating that the Channel 1 width trigger polarity setting for search 1 is set to
POSITIVE .
SEARCH:SEARCH<x>:TRIGger:A:WIDth:POLarity:MATH<x>
This command sets or queries the polarity for a width trigger search to determine
where to place a mark. <x> is the search number or math waveform number.
Group
Search and Mark
Syntax
SEARCH:SEARCH<x>:TRIGger: A:WIDth:POLarity:MATH<x>
{NEGAtive|POSITIVe}
SEARCH:SEARCH<x>:TRIGger: A:WIDth:POLarity:MATH<x>?
Arguments
NEGAtive specifies a negative polarity.
POSITIVe specifies a positive polarity.
2-480 DPO7000, DPO70000/B and DSA7000/B Series Programmer Manual