Tektronix DPO70000 Series

Commands Listed in Alphabetical Order
Examples
TRIGGER:A:COM
MUNICATION:AMI:THRESHOLD:LOW 2.8E-2
sets the
threshold low level to 2.8E-2.
TRIGGER:A:CO
MMUNICATION:AMI:THRESHOLD: LOW?
might return
:TRIGGER:A:COMMUNICATION:A MI:THRESHOLD:LOW 2.8E-2, indicating the
threshold low level in volts.
TRIGger:A:
COMMunication:BITRate
This command sets or queries the bit rate.
Conditions
This command is only valid if the instrument has Option MTM is installed
Group
Trigger
Syntax
TRIGger:A:COMMunication:BI TRate <NR3>
TRIGger:A:COMMunication:BI TRate?
Arguments
<NR3> is a nonnegative number greater than one and expressed as bits per second.
Exampl
es
TRIGGER:A:COMMUNICATION:BI TRATE 1.544E6 sets the bit rate to
1.544 Mb/s.
TRIGGER:A:COMMUNICATION:BI TRATE ? might return
:TRIGGER:A:COMMUNICATION:B ITRATE 1.544e6, indicating a bit
rate of 1.544 Mb/s.
TRIGger:A:COMMunication:CLOCk:POLarity
This command sets or queries the communication clock polarity
Conditions
This command is only v alid if the instrument has Option MTM is installed.
Group
Trigger
Syntax
TRIG
ger:A:COMMunication:CLOCk:PO Larity {RISe|FALL}
TRIGger:A:COMMunication:CL OCk:POLarity?
DPO7000, DPO70000/B and DSA7000/B Series Programmer Manual 2-559