Commands Listed in Alphabetical Order
Arguments
DEFAULT assign
s color reference traces to the nominal palette reference color,
which is off-white.
INHERIT assig
ns color reference traces to the source waveform color.
Examples
DISPLAY:COLOR:REFCOLOR DEFAULT assigns color reference traces to the
nominal palette reference color, which is off-white.
DISPLAY:COLOR:REFCOLOR? might return :DISPLAY:COLOR:REFCOLOR
INHERIT
, indicating that source waveform color is used for reference traces.
DISplay:FILTer
This command sets or queries the type of interpolation to use for the display.
Filtering only applies to normal-mode acquisition. The DISplay:FILTer command
also provides selection for acquisition interpolation type. This command is
equivalent to selecting Waveform Interpolation from the Display menu.
Group
Display Control
Syntax
DISplay:FILTer {LINEAr|SINX}
DISplay:FILTer?
Arguments
LINEAr specifies linear interpolation, where acquired points are connected with
straight lines.
SINX specifies sin(x)/x interpolation, where acquired points are fittoacurve.
Examples
DISPLAY:FILTER SINX specifies sine-curve interpolation, when magnifying
waveforms.
DISPLAY:FILTER? might return :DI SPLAY:FILTER LINEAR, indicating that
straight-line interpolation is specified for magnifying waveforms.
DISplay:FORMat
This command sets or queries the display format. This command is equivalent to
selecting Format from the Display menu.
Group
Display Control
DPO7000, DPO70000/B and DSA7000/B Series Programmer Manual 2-187
To Next Page
Loading...
Need help?
General
