Tektronix DPO70000 Series Programmer's Manual

Commands Listed in Alphabetical Order
This command is
not IEEE 488.2 compliant for the following reasons:
The command produces output on the 488.2 bus. Queries, not commands, are
the only messa
ge units that should produce output on the 488.2 bus. Errors
may not be recognized if they occur while data is being output in response to
this command. This will be evident if a command is sent to the instrument
before all of the data generated by this command has been read. In such cases,
you should send a device clear message to the instrument.
The command does not use a standard 488.2 output format. The closest
defined format is the indefinite format of ARBITRARY BLOCK PROGRAM
DATA encoding. However, this command output omits the initial ’#0’
characte
rs needed for that format.
Newlines, ASCII value 10, can be included in the output data. Output on
the bus c
an be terminated by newlines. The output of this command is only
terminated by <EOI>.
Group
File System
Syntax
FILESystem:READFile <filepath>
Related Commands
FILESystem:CWD, FILESystem:PRInt
Arguments
<file p at
h>
is a quoted string that defines the file name and path. If the file
path is within the current working directory, you need only specify the file name.
Examples
FILESYSTEM:READFILE "C:\TEK00000.IBM " sends the file named
TEK00000.IBM out of the GPIB port.
FILESystem:REName (No Query Form)
This command (no query form) assigns a new name to an existing file.
Group
File System
Syntax
FILESystem:REName <old file path>,<new fil
e path>
Related Commands
FILESystem:CWD
DPO7000, DPO70000/B and DSA7000/B Series Programmer Manual 2-223

Tektronix DPO70000 Series Specifications

General

Brand	Tektronix
Model	DPO70000 Series
Category	Test Equipment
Language	English