To Next Page

To Previous Page

Commands Listed in Alphabetical Order

Arguments

ACCept speciﬁe

s that the instrument will only trigger on pulses that are narrower

than the speciﬁed width, when the trigger type is set to glitch. The width is

speciﬁed using the TRIGger:{A|B}:PULse:GLItch:WIDth command.

REJect speciﬁes that the instrument will only trigger on pulses that are wider than

the speciﬁed width, when the trigger type is set to glitch. The width is speciﬁed

using the TRIGger:{A|B}:PULse:GLItch:WIDth command.

Examples

TRIGGER:A:PULSE:GLITCH:TRI GIF REJECT speciﬁes that the instrument

triggers on pulses that are wider than the speciﬁed width.

TRIGGER:A:PULSE:GLITCH:TRI GIF ACCEPT? might return

:TRIGGER:A:PULSE:GLITCH:TR IGIF ACCEPT, indicating that the instrument

is set to trigger on pulses that are narrower than the speciﬁed width.

TRIGger:{A|B}:PULse:GLItch:WIDth

This co

mmand sets or queries the width for the glitch trigger. This command

is equivalent to selecting Glitch Setup from the Trig menu and then setting the

desired Width.

For information about using the width value, refer to the TRIGger:{A|B}:PULse:

GLItch:TRIGIF command.

Group

Trigger

Syn

tax

TRIGger:{A|B}:PULse:GLItch :WIDth <NR3>

TRIGger:{A|B}:PULse:GLItch :WIDth?

Related Commands

TRIGger:{A|B}:LEVel, TRIGger:{A|B}:PULse:GLItch:TRIGIF

Arguments

<NR3> argument speciﬁes the width of the glitch in seconds.

Examples

TRIGGER:A:PULSE:GLITCH:WID TH 15E-6 sets the width of the glitch to 15 µs.

TRIGGER:A:PULSE:GLITCH:WID TH? might return

:TRIGGER:A:PULSE:GLITCH:WI DTH 2.0000E-09, indicating that the width

of the glitch is c urrently set at 2 ns.

DPO7000, DPO70000/B and DSA7000/B Series Programmer Manual 2-525

Tektronix DPO70000 Series Programmer's Manual

Other manuals for Tektronix DPO70000 Series