Commands Listed in Alphabetical Order
Group
Vertical
Syntax
CH<x>:PRObe:SET {<QString>}
CH<x>:PRObe:SET?
Arguments
QString is a quoted string representing a settable aspect of the attached
accessory. Example strings for some pro bes are shown as follows:
ATTENuation 5X sets the P7260 probe to ±0.75 V dynamic range with 6 GHz
bandwidth and 5X attenuation.
ATTENuation 25X sets the P7260 probe to ±3 V d ynamic range with 6 GHz
bandwidth and 25X attenuation.
VTERMsource AUTO sets the P7380SMA probe voltage termination source to
auto.
VTERMsource INTernal sets the P7380SMA probe voltage termination source
to internal.
VTERMsource EXTernal sets the P7380SMA probe voltage termination source
to external.
Examples
"ATTEN 25X" sets the P7260 probe to the selection for ±3 V dynamic range with
3 GHz bandwidth and 25X attenuation.
CH1:PRObe:SET? might return :CH2:PROBE:SET "ATTENUATION 5X"
indicating that the P7260 probe is set to the selection for ±0.75 V dynamic range
with 6 GHz bandwidth and 5X attenuation.
CH2:PRObe:SET? "ATTEN" might return :CH2:PROBE:SET "ATTENUATION
25X"
, indicating that the P7260 probe is set to the selection for ±3 V dynamic
range with 3 GHz bandwidth and 25X attenuation.
CH<x>:PRObe:SIGnal
This command sets or queries aspects of probe accessory user interfaces. The
available arguments for this command will vary depending on the accessory you
attach to the instrument.
Group
Vertical
Syntax
CH<x>:PRObe:SIGnal {PASS|BYPass}
CH<x>:PRObe:SIGnal?
DPO7000, DPO70000/B and DSA7000/B Series Programmer Manual 2-123
To Next Page
Loading...
Need help?
General
