Commands Listed in Alphabetical Order
AUXIN:PROBE:I
NPUTMODE:AOFFSET
? might return :AUXIN:PROBE:
INPUTMODE:AOFFSET 0.0000
, indicating that the A mode offset control is
set to 0 V.
AUXIn:PRObe
:INPUTMode:BOFFSet
This command sets or returns the requested B mode offset control of the probe
that is attached to the AUX In input.
Group
Vertical
Syntax
AUXIn:PRObe:INPUTMode:BOFF Set
AUXIn:PRObe:INPUTMode:BOFF Set?
Arguments
NR3 specifies the B mode offset control.
Examples
AUXIN:PROBE:INPUTMODE:BOFF SET 0.2 sets the B mode offset control to
0.2 V.
AUXIN:PROBE:INPUTMODE:BOFF SET? might return :AUXIN:PROBE:
INPUTMODE:BOFFSET? “0.0000”
, indicating that the B mode offset control
issetto0V.
AUXIn:PRObe:INPUTMode:CMOFFSet
This command s ets or returns the requested common mode offset control of the
probe that is attached to the AUX In input.
Group
Vertical
Syntax
AUXIn:PRObe:INPUTMode:CMOF FSet
AUXIn:PRObe:INPUTMode:CMOF FSet?
Arguments
NR3 specifies the common mode offset control
Examples
AUXIN:PROBE:INPUTMODE:CMOF FSET 0.2 sets the common mode offset
control to 0.2 V.
DPO7000, DPO70000/B and DSA7000/B Series Programmer Manual 2-93
To Next Page
Loading...
