Tektronix DPO70000 Series

Commands Listed in Alphabetical Order
MEASUrement?
(Query Only)
This query-only command returns all measurement parameters in the following
order: MEAS1, MEAS2, MEAS3, MEAS4, MEAS5, MEAS6, MEAS7, MEAS8,
and IMMED.
Group
Measurement
Syntax
MEASUrement?
Examples
MEASUREMENT? might return :MEASUREMENT:GATING
OFF;IMMED:TYPE UNDEF
INED;UNITS "V";SOURCE1 C H1;SOURCE2
CH1;SOURCE1:SIGTYPE PULSE;:MEASUREM ENT:IMMED:SOURCE 2:SIGTYPE
PULSE;:MEASUREMENT:IMMED:D ELAY:EDGE1 RISE;EDGE2
RISE;DIRECTION FORWARDS;:MEASUREMEN T:IMMED:REFLEVEL :METHOD
PERCENT;ABSOLUTE:HIGH 0.0000;LOW 0.0000;MID1 0. 0000;MID2
0.0000;:MEASUREMENT:IMMED: REFLEVEL:PERCENT:HIGH 90. 0000;LOW
10.0000;MID1 50.00
00;MID2 50.0000;:MEASUREMENT:IMMED:METHOD
HISTOGRAM;NOISE HIGH;:MEASUREMENT:M EAS1:STATE
0;TYPE UNDEFINED;UNITS "V";SOURCE1 CH1;SOURCE2
CH1;SOURCE1:SIGTYPE PULSE;:MEASUREM ENT:MEAS1:SOURCE 2:SIGTYPE
PULSE;:MEASUREMENT:MEAS1:D ELAY:EDGE1 RISE;EDGE2
RISE;DIRECTION FORWARDS;:MEASUREMEN T:MEAS1:REFLEVEL :METHOD
PERCENT;ABSOLU
TE:HIGH 0 .0000;LOW 0.0000;MID1 0.0000;MID2
0.0000;:MEASUREMENT:MEAS1: REFLEVEL:PERCENT:HIGH 90. 0000;LOW
10.0000;MID1 50.0000;MID2 50.0000;:MEASUREMENT:MEAS1:METH OD
HISTOGRAM;NOISE HIGH;:MEASUREMENT:M EAS2:STATE
0;TYPE UNDEFINED;UNITS "V";SOURCE1 CH1;SOURCE2
CH1;SOURCE1:SIGTYPE PULSE;:MEASUREM ENT:MEAS2:SOURCE 2:SIGTYPE
PULSE;:MEASU
REMENT:MEAS2:DELAY:EDGE1 RISE;EDGE2
RISE;DIRECTION
.
MEASUrement:ANNOTation:IMMEDSTAte
This command sets or queries the state of immediate measurement annotation.
Group
Measurement
Syntax
MEASUrement:ANNOTation:IMM EDSTAte {<NR1>|OFF|ON}
MEASUrement:ANNOTation:IMM EDSTAte?
DPO7000, DPO70000/B and DSA7000/B Series Programmer Manual 2-363