Commands Listed in Alphabetical Order
Arguments
NR3 specifies th
e A mode offset control.
Examples
CH1:PROBE:INPUTMODE:AOFFS ET 5.0 sets the requested A mode offset
control of the probe that is attached to the Channel 1 to its 5 Ampere range.
CH1:PROBE:INPUTMODE:AOFFS ET? might return
:CH1:PROBE:INPUTMODE:AOFF SET? 0.0000, indicating that the requested A
mode offset control of the probe that is attached to the Channel 1 is set to 0 .0.
CH<x>:PRObe:INPUTMode:BOFFSet
This command sets or
queries the requested B mode offset control of the probe
that is attached to the specified channel.
Group
Vertical
Syntax
CH<x>:PRObe:INPUTMode:BOF FSet
CH<x>:PRObe:INPUTMode:BOF FSet
CH<x>:PRObe:INPUTMode:BOF FSet?
Arguments
NR3 specifies the B mode offset control.
Examples
CH1:PROBE:INPUTMODE:BOFFS ET 5.0 sets the requested B mode offset
control of the probe that is attached to the Channel 1 to its 5 Ampere range.
CH1:PROBE:INPUTMODE:BOFFS ET? might return
:CH1:PROBE:INPUTMODE:BOFF SET 0.0000, indicating that the requested A
mode offset control of the probe that is attached to the Channel 1 is set to 0 .0.
CH<x>:PRObe:INPUTMode:CMOFFSet
This command sets or queries the requested common mode offset control of the
probe that is attached to the s peci fi ed channel.
Group
Vertical
Syntax
CH<x>:PRObe:INPUTMode:CMO FFSet
CH<x>:PRObe:INPUTMode:CMO FFSet?
Arguments
NR3 specifies the common m ode offset control.
2-120 DPO7000, DPO70000/B and DSA7000/B Series Programmer Manual
To Next Page
Loading...
Need help?
General
