Tektronix DPO70000 Series Programmer's Manual

Commands Listed in Alphabetical Order
Group
Low Speed Seria
l Trigger
Syntax
TRIGger:A:CAN:FRAMEtype {DATA|REMote|ERRO R|OVERLOAD}
TRIGger:A:CAN:FRAMEtype?
Arguments
DATA specifiesadataframetype.
REMote specifiesaremoteframetype.
ERROR specifies an error frame type.
OVERLOAD specifies an overload frame type.
Examples
TRIGGER:A:CAN:FRAMETYPE DATA sets the CAN trigger frame type to data.
TRIGGER:A:CAN:FRAMETYPE? might return
:TRIGGER:A:CAN:DATA:FRAMET YPE REMOTE, indicating that the CAN trigger
frame type is set to remote.
TRIGger:A:CAN:IDENTifier:MODe
CAN option only: This command sets or queries the CAN trigger identifier mode.
Group
Low Speed Serial Trigger
Syntax
TRIGger:A:CAN:IDENTifier:M ODe {STANdard|EXTENded}
TRIGger:A:CAN:IDENTifier:M ODe?
Arguments
STANdard sets the CAN trigger identifier mode to standard mode.
EXTENded sets the CAN trigger identifier mode to extended mode.
Examples
TRIGGER:A:CAN:IDENTIFIER:M ODE STANDARD sets the CAN trigger identifier
mode to standard.
TRIGGER:A:CAN:IDENTIFIER:M ODE? might return
:TRIGGER:A:CAN:IDENTIFIER: MODE EXECUTE, indicating that the CAN
trigger identifier mode is set to extended.
TRIGger:A:CAN:IDENTifier:VALue
CAN option only: This command sets or queries the binary address string used
for the CAN trigger if the trigger condition is ID or IDANDDATA.
DPO7000, DPO70000/B and DSA7000/B Series Programmer Manual 2-555

Tektronix DPO70000 Series Specifications

General

Brand	Tektronix
Model	DPO70000 Series
Category	Test Equipment
Language	English