Commands Listed in Alphabetical Order
Syntax
MASK:TESt:WAV
Eform <NR1 >
MASK:TESt:WAVEform?
Arguments
<NR1> is an integer that sets the number of tested (sampled or averaged)
waveforms to test for each pass/fail test.
Examples
MASK:TEST:WAVEFORM 20 sets the number of failures that would cause a test
failure to 20.
MASK:TEST:WAVEFORM? might return
:MASK:TEST:WAVEFORM 50, indicating that the 50 failures would cause a test
failure.
MASK:USER:AMPlitude
This command sets or returns the current mask’s nominal pulse amplitude in
volts. The query form of this command returns the nominal pulse amplitude of
the displayed mask. The set form of this command only affects the user mask,
regardless of the current (displayed) mask.
Group
Mask
Syntax
MASK:USER:AMPlitude <NR3>
MASK:USER:AMPlitude?
Related Commands
MASK:USER:VSCAle
Arguments
<NR3> is a floating number that sets the nominal pulse amplitude in volts.
Examples
MASK:USER:AMPLITUDE 2.4 sets the user mask nominal pulse amplitude to
2.4 volts.
MASK:USER:AMPLITUDE? might return
:MASK:USER:AMPLITUDE 100.0000E–3, indicating that the user mask nominal
pulse amplitude to set to 0.1 volts.
MASK:USER:BITRate
This command sets or returns the bit rate for the user mask.
DPO7000, DPO70000/B and DSA7000/B Series Programmer Manual 2-335
To Next Page
Loading...
Need help?
General
