Commands Listed in Alphabetical Order
Group
Vertical
Syntax
SELect:<wfm> {ON|OFF|<NR1>}
SELect:<wfm>?
Arguments
ON turns on the display of the specified waveform. This waveform also becomes
the selected waveform.
OFF turns o ff the display of the specified waveform.
<NR1> = 0 turns off the display of the specified waveform; any other value turns
on the display of the specified waveform.
Examples
SELECT:CH2 ON turns the channel 2 waveform display on, and selects Channel 2.
SELECT:REF1? might return :SE LECT:REF1 1, indicating that Reference 1
waveform is being displayed.
SET? (Query Only)
This query-only command returns the commands that list the instrument settings,
except for configuration information for the calibration values. You can use these
commands to return the instrument to the state it was in when you made the SET?
query. The SET? query always returns command headers, regardless of the setting
of the HEADer command. This is because the returned commands are intended
to be sent back to the instrument as a command string. The VERBose command
can still be used to specify whether the returned headers should be abbreviated
or full-length.
This command is identical to the *LRN? command.
Group
Miscellaneous
Syntax
SET?
Related Commands
HEADer, *LRN?, VERBose
Examples
SET? might return the following response: :ACQUIRE:STOPAFTER
RUNSTOP;STATE 1;MODE S AMPLE;NUMENV 10;NUMAVG 16;REPET
1;:FASTACQ:STATE 0;:APPLICATION:GPK NOB1:ACTIVE
0;:APPLICATION:GPKNOB2:ACT IVE 0;:APPLICATION:WINDOW:HEIGH T
236;WIDTH 640;:APPLICATION:SCOPEAPP:STATE
RUNNING;WINDOW FULLSCREEN;:APPLICAT ION:EXTAPP:STATE
DPO7000, DPO70000/B and DSA7000/B Series Programmer Manual 2-489
To Next Page
Loading...
Need help?
General
