Tektronix DPO70000 Series Programmer's Manual

Commands Listed in Alphabetical Order
Syntax
CURSor:VBArs S
NAp
CURSor:VBArs?
Related Commands
DATa:STARt, D
ATa:STOP
Arguments
SNAp forces the position of vertical bar cursor 1 and 2 to snap to the waveform
record poin
ts specified by the DATA:START and DATA :STOP commands,
respectively.
Examples
CURSOR:V
BARS SNA p
forces vertical bar cursor1 to the DATA:START position
and vertical bar cursor 2 to the DATA:STOP position.
CURSOR:VBARS? might return the following vertical bar settings
:CURSOR:VBARS:UNITS SECONDS;POSITIO N1 1.0000E-06;POSITION2
9.0000E-06
.
CURSor:VBArs:DELTa? (Query Only
)
This query-only command returns the horizontal difference between the two
vertical bar cursors. The units are specified by the CURSor:VBArs:UNIts
command. The position can appear
in units of Base or 1/Base.
Group
Cursor
Syntax
CURSor:VBArs:DELTa?
Related Commands
CURSor:VBArs:UNIts
Returns
A floating point value with an exponent.
Examples
CURSOR:VBARS:DELTA? might return :CURSOR :VBARS:DELTa 1.0640E+00,
indicating that the time between the vertical bar cursors is 1.064 s.
CURSor:VBArs:POSITION<x>
This command sets or queries the horizontal position for vertical bar cursors. The
cursor is specified by x, which can be 1 or 2. Values are with respect to trigger
position or the zero reference point for the designated waveform (if horizontal
units are not set to time). Use the CURSor:VBArs:UNIts command to specify
units. The position can appear in units of base or 1/base.
2-138 DPO7000, DPO70000/B and DSA7000/B Series Programmer Manual

Tektronix DPO70000 Series Specifications

General

Brand	Tektronix
Model	DPO70000 Series
Category	Test Equipment
Language	English