Tektronix DPO70000 Series

Commands Listed in Alphabetical Order
TRIGger:B:TI
Me
This command sets or queries B trigger delay time. The B Trigger time applies
only if TRIGger:B:BY is set to TIMe. This command is equivalent to selecting B
Event (Delay
ed) Trigger Setup from the Trig menu, choosing the A®B Seq tab,
and setting Trig Delay.
Group
Trigger
Syntax
TRIGger:B:TIMe <NR3>
TRIGger:B:TIMe?
Related Commands
TRIGger:B:BY, TRIGger:B:EVENTS:COUNt TRIGger:B:STATE
Arguments
<NR3> is the B trigger d elay time in seconds.
Examples
TRIGGER:B:TIME 4E-6 sets the B trigger delay time to 4 µs.
TRIGGER:B:TIME? m
ight return
:TRIGGER:B:TIME 16.0000E-9, indicating
that the B trigger time is set to 16 ns.
TRIGger:B:TYPe
This command sets or queries the type of B trigger. This command is equivalent to
selecting B Event (Delayed) Trigger Setup from the Trig menu and choosing Edge.
Group
Trigger
Syntax
TRIGger:B:TYPe {EDGE|PULse|LOGIc}
TRIGger:B:TYPe?
Related Commands
TRIGger:A:TYPe TRIGger:B:STATE
Arguments
EDGe sets the B trigger type to edge.
PULse specifies that a trigger occ
urs when a specified pulse is found and is
controlledbythe
TRIGger:B:PULse commands.
LOGIc specifi es that a trigger oc
curs when specified conditions are met and is
controlledbythe
TRIGger:B:LOGIc commands.
2-616 DPO7000, DPO70000/B and DSA7000/B Series Programmer Manual