Tektronix DPO70000 Series Programmer's Manual

Commands Listed in Alphabetical Order
Syntax
SEARCH:SEARCH
<x>:TRIGger:A:SETHold:CLOCk: THReshold:REF<x>
{NR3|ECL|TTL}
SEARCH:SEARCH<x>:TRIGger: A:SETHold:CLOCk:THReshold:REF<x>?
Arguments
<NR3> is the clock level, in volts.
ECL specifies a preset ECL high level of -1.3 V.
TTL specifies a preset TT L high level of 1.4 V.
Examples
SEARCH:SEARCH1:TRIGGER:A: SETHOLD:CLOCK:THRESHOLD:REF2 ECL
sets the c lock threshold setting of the Reference 2 waveform for a setup/hold
trigger search to ECL.
SEARCH:SEARCH1:TRIGGER:A: SETHOLD:CLOCK:THRESHOLD:REF1? might
return
:SEARCH:SEARCH1:TRIGGER:A:SE THOLD:CLOCK:THRESHOLD:REF1
1.0000
, indicating that the clock threshold setting o f the Reference 1 waveform
forasetup/holdtriggersearchissetto1volt.
SEARCH:SEARCH<x>:TRIGger:A:SETHold:DATa:SOUrce
This command sets or queries the data source setting for a setup/hold trigger
search to determine where to place a mark. <x> is the search number.
Group
Search and Mark
Syntax
SEARCH:SEARCH<x>:TRIGger: A:SETHold:DATa:SOUrce
{CH1|CH2|CH3|CH4|MATH1|MA TH2|MATH3|MATH4|REF1|REF2|REF3|REF4
SEARCH:SEARCH<x>:TRIGger: A:SETHold:DATa:SOUrce?
Arguments
CH<x> specifies an input channel as the search source, where <x> = 1, 2, 3 or 4.
MATH<x> specifies the math waveform as the search source, where <x> = 1, 2, 3
or 4.
REF<x> specifies the reference waveform as the se arch source, where <x> =
1, 2, 3 or 4.
Examples
SEARCH:SEARCH1:TRIGGER:A: SETHOLD:DATA:SOURCE MATH1 sets the
setup/hold trigger data source setting for search 1 to the Math 1 waveform.
SEARCH:SEARCH1:TRIGGER:A: SETHOLD:DATA:SOURCE? might return
:SEARCH:SEARCH1:TRIGGER:A :SETHOLD:DATA:SOURCE CH1, indicating that
the setup/hold trigger data source setting for search 1 is set to the Channel 1.
2-464 DPO7000, DPO70000/B and DSA7000/B Series Programmer Manual

Tektronix DPO70000 Series Specifications

General

Brand	Tektronix
Model	DPO70000 Series
Category	Test Equipment
Language	English