Tektronix DPO70000 Series Programmer's Manual

Command Groups
The p rogrammable interface conforms to Tektronix standard codes and formats
except where noted. The GPIB interface also conforms to IEEE Std 488.2-1987
except where
noted.
Acquisition Command Group
Use the com
mands in the Acquisition Command Group to set up the m odes and
functions that control how the instrument acquires the signals you input to the
channels and processes them into waveforms.
Using these commands for acquiring waveforms, you can do the following:
Start and
stop acquisitions.
Control whether each waveform is simply acquired, averaged, or enveloped
over suc
cessive acquisitions of that waveform.
Set the controls or conditions that start and stop acquisitions.
Determine the action the system takes upon completing an acquisition, such
as saving all waveforms and taking a measurement when the acquisition is
stopp
ed.
Control acquisition of acquired channel waveforms.
Set acquisition parameters.
Table 2-13: Acquisition Commands
Command Description
ACQuire?
Returns acquisition parameters
ACQuire:INTERPEightbit Sets or returns the interpolation acquisition
mode
ACQuire:MODe Sets or returns acquisition mode
ACQuire:NUMFRAMESACQuired? Returns the number of acquisitions that have
occurred
ACQuire:NUMACq? Returns the number of waveform acquisitions
that have occurred since starting acquisition
with the ACQuire:STATE RUN command
ACQuire:NUMAVg Sets or returns number of acquisitions for an
averaged waveform
ACQuire:NUMEnv Sets or returns number of acquisitions for
envelope waveform
ACQuire:NUMSAMples Sets or returns the number of samples that
make up a WfmDB for single sequence
mode and Mask Pass/Fail Completion Test
DPO7000, DPO70000/B and DSA7000/B Series Programmer Manual 2-11

Tektronix DPO70000 Series Specifications

General

Brand	Tektronix
Model	DPO70000 Series
Category	Test Equipment
Language	English