Commands Listed in Alphabetical Order
CURSor:WAVEf
orm:POSition<x>
This command sets or queries the position of a waveform cursor, which is
constrained to be visible in the selected time base. (Use the CURSor:FUNCtion
commandtose
t the cursor function to Waveform.) The cursor is specified by x,
which can be 1 or 2. This is equivalent to setting a value in the Position control in
the Cursor1 or Cursor2 sections of the Cursor Setup dialog box (when Waveform
is selected in the Function section).
Group
Cursor
Syntax
CURSor:WAVEform:POSition< x> {<NR3>}
CURSor:WAVEform:POSition< x>?
Related Commands
CURSor:FUNCtion
Arguments
<NR3> specifies the cursor position measured relative to the time o f the trigger
point of the source wavef
orm.
Examples
CURSor:WAVEform:POSition2 9.00E-6 sets the waveform cursor 2 position
to 9 μs.
CURSor:WAVEform:POSition2 ? might return
:CURSOR:WAVEFORM:POSITION 2 51.0701402806E-009, indicating
waveform cursor 2 is at 51.1 ns.
CURSor:WAVEform:STYle
This command sets or queries the cursor type for Waveform mode.
Group
Cursor
Syntax
CURSor:WAVEform:STYle {LINE_X|LINES|X}
CURSor:WAVEform:STYle?
Arguments
LINE_X specifies the cursor style to be a line with superimposed X.
LINES specifies the cursor style to be a line.
X specifies the cursor style to be an X.
2-142 DPO7000, DPO70000/B and DSA7000/B Series Programmer Manual
To Next Page
Loading...
Need help?
General
