Tektronix DPO70000 Series Programmer's Manual

Commands Listed in Alphabetical Order
Syntax
TRIGger:A:VID
eo:SCAN {R ATE1|RATE2|RATE 3|RATE4|RATE5}
TRIGger:A:VIDeo:SCAN?
Arguments
RATE1 argument sets the range of the video line scan rate to 15 kHz through
20 kHz. This is the standard broadcast rate.
RATE2 argument sets the range of the video line scan rate to 20 kHz through
25 kHz.
RATE3 argument sets the range of the video line scan rate to 25 kHz through
35 kHz.
RATE4 argument sets the range of the video line scan rate to 35 kHz through
50 kHz.
RATE5 argument sets the range of the video line scan rate to 50 kHz through
65 kHz.
Examples
TRIGGER:A:VIDEO:SCAN RATE1 sets the scan r ate of the A video trigger to
Rate 1, which is 15 kHz to 20 kHz (standard broadcast rate).
TRIGGER:A:VIDEO:SCAN? might return :TRIGGER:A:VIDEO:SCAN RATE2,
indicating that the video line rate for the A trigger is set to Rate 2, which is
20 kHz to 23 kHz.
TRIGger:A:VIDeo:SOUrce
DPO7000 Series only: This command sets or queries the source for the A video
trigger. This command is equivalent to selecting Video Setup from the Trig menu
and selecting a channel from the Source drop-down menu.
Group
Trigger
Syntax
TRIGger:A:VIDeo:SOUrce CH<x>
TRIGger:A:VIDeo:SOUrce?
Arguments
CH<x> argument specifies one of the input channels of the instrument as the A
video trigger. The value of x ranges from 1 through 4.
Examples
TRIGGER:A:VIDEO:SOURCE CH1 sets the source for A video trigger to
Channel 1.
TRIGGER:A:VIDEO:SOURCE? might return :TRIGGER:A:VIDEO: SOURCE CH2,
indicating that the source for the A video trigger is set to Channel 2.
DPO7000, DPO70000/B and DSA7000/B Series Programmer Manual 2-605

Tektronix DPO70000 Series Specifications

General

Brand	Tektronix
Model	DPO70000 Series
Category	Test Equipment
Language	English