Commands Listed in Alphabetical Order
Examples
TRIGGER:A:PUL
SE:RUNT:THRESHOLD?
might return
:TRIGGER:A:PULSE:THRESHOLD :HIGH 2.0000E+00; LOW 8.0000E-01,
indicating that the upper threshold is 2 V and that the lower threshold is set to
0.8 V.
TRIGger:{A|B}:PULse:RUNT:THReshold:BOTh (No Query Form)
This command (no query form) sets the upper and lower switching thresholds for
the pulse r
unt trigger. This command is equivalent to selecting Runt Setup from
the Trig menu and then setting the Upper Level and Lower Level voltages.
Group
Trigger
Syntax
TRIGger:{A|B}:PULse:RUNT:T HReshold:BOTh {TTL|ECL}
Related Commands
TRIGger:{A|B}:PULse:RUNT:THReshold?
Arguments
TTL sets the upper and lower threshold to the nominal TTL voltage levels.
ECL sets the upper and lower threshold to the nominal ECL voltage levels.
Examples
TRIGGER:A:PULSE:RUNT:THRES HOLD:BOTH TTL sets the threshold of the
pulse runt trigger to the nominal TTL voltage levels.
TRIGger:{A|B}:PULse:RUNT:THReshold:HIGH
This command sets or queries the upper limit for the pulse runt trigger. This
command is equivalent to selecting Runt Setup from the Trig menu and setting
the runt trigger Upper Level voltage.
Group
Trigger
Syntax
TRIGger:{A|B}:PULse:RUNT:T HReshold:HIGH <NR3>
TRIGger:{A|B}:PULse:RUNT:T HReshold:HIGH?
Related Commands
TRIGger:{A|B}:PULse:RUNT:THReshold?
Arguments
<NR3> specifies the threshold value, in volts.
DPO7000, DPO70000/B and DSA7000/B Series Programmer Manual 2-529
To Next Page
Loading...
Need help?
General
