Commands Listed in Alphabetical Order
the halt contro
l is set to off using the DIAg:CONTROL:HALT command or that
the halt control is set to ON but no failures occur). This command is equivalent
to selecting Instrument Diagnostics from the Utilities menu and then enabling
Loop Control.
Group
Diagnostics
Syntax
DIAg:CONTROL:LOOP {ON|OFF|<NR1>}
DIAg:CONTROL:LOOP?
Related Commands
DIAg:CONTROL:HALT, DIAg:STOP
Arguments
ON enables the loop function, causing the execution of diagnostics to continuously
loop.
OFF disables the loop function, causing the instrument to execute the entire set of
diagnostics once and then halt.
<NR1> = 0 enables the loop function; any other value disables the loop function.
Examples
DIAG:CONTROL:LOOP ON enables the loop function.
DIAG:CONTROL:LOOP? might return :DI AG:CONTROL:LOOP 0, indicating that
looping on diagnostics is enabled.
DIAg:EXECUTE (No Query Form)
This command (no query form) starts the execution of the currently selected set
of diagnos tics. This command is equivalent to selecting Instrument Diagnostics
from the Utilities menu and then pressing Run.
Group
Diagnostics
Syntax
DIAg:EXECUTE
Related Commands
DIAg:STATE
Examples
DIAG:EXECUTE starts the execution of the entire set of diagnostics.
2-164 DPO7000, DPO70000/B and DSA7000/B Series Programmer Manual
To Next Page
Loading...
Need help?
General
