Commands Listed in Alphabetical Order
Syntax
CURVEStream {<
Block>|<asc curve>}
CURVEStream?
Related Commands
CURVe, DA
Ta:DESTination, DATa:SOUrce, DATa:STARt, DATa:STOP,
SAVe:WAVEform, SAVe:WAVEform:FILEFormat, WFMInpre? ,
WFMInpre:BYT_Nr, WFMOutpre?, WFMInpre:NR_FR, WFMOutpre:NR_FR?
Arguments
Se
etheCURVe command.
Returns
Waveform data in its native binary format. To save processing time, DATa:ENCdg
FASTEST is set and waveform d ata is shipped in its raw native format.
DATa
This command sets or queries the format and location of the waveform data that is
transferred with the CURVe command.
Group
Waveform Transfer
Syntax
DATa {I NIT|SNAp}
DATa?
Related Commands
CURVe, DATa:STARt, DATa:STOP, DATa:ENCdg, SAVe:WAVEform:
FILEFormat, WFMInpre:NR_FR, WFMInpre:NR_Pt, WFMOutpre:NR_FR?,
WFMOutpre:NR_Pt?
Arguments
INIT initializes the waveform data parameters to their factory defaults.
SNAp sets DATa:STARt and DATa:STOP to match the current V Bar/Paired/Split
cursor positions.
Examples
DATA INIT initializes the waveform data parameters to their factory defaults.
DATA? might return :DATA:DESTINATION REF1;ENCDG RIBINARY;SOURC E
CH1;START 1;STOP 1000; FRAMESTART 1;FRAMESTOP 1000
.
DATa:DESTination
This command sets or queries the referen ce memory location for storing waveform
data that is transferred into the instrument by the CURVe command.
DPO7000, DPO70000/B and DSA7000/B Series Programmer Manual 2-153
To Next Page
Loading...
Need help?
General
